Table of Contents
Advertisement
Wi-Fi
Increasing the time between rekeys can improve connectivity issues in noisy environments. To
disable group rekeys, set to 0. This will allow any client that has previously connected to see
all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
11. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Configure a bridge
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
12. Click Apply to save the configuration and apply the change.
Command line
Configure a new Access point
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new access point:
(config)> add network wifi ap new_AP
(config network wifi ap new_AP)>
New access points are enabled by default.
4. Set the SSID for the Wi-Fi access point. Up to 32 characters are allowed.
(config network wifi ap new_AP)> ssid my_SSID
(config network wifi ap new_AP)>
SSID broadcasting is enabled by default for new access points.
5. Set the security for the access point to a personal security option:
(config network wifi ap new_AP)> encryption type value
(config network wifi ap new_AP)>
where value is one of:
psk: Uses WPA Personal (PSK). All Wi-Fi clients must support WPA to be able to
n
authenticate.
mixedpsk: Uses mixed WPA/WPA2 Personal (PSK) mode. Wi-Fi clients that support WPA
n
and WPA2 are able to authenticate.
IX20 User Guide
Configure a Wi-Fi access point with personal security
for more information.
Configure a LAN
and
202
Advertisement
Table of Contents
