Table of Contents
Advertisement
Wi-Fi
h. To add a channel, click Add Scan frequency and select the appropriate channel.
7. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new Wi-Fi client:
(config)> add network wifi client new_client
(config network wifi client new_client)>
New clients are enabled by default.
4. Configure the Wi-Fi network that the client will use:
a. Set the SSID of the access point that the client will use to connect to the Wi-Fi network:
(config network wifi client new_client)> ssid 0 ssid value
where value is the SSID of the access point.
b. Set the security for the access point:
(config network wifi client new_client)> ssid 0 encryption type value
(config network wifi client new_client)>
IX20 User Guide
Configure a Wi-Fi client and add client networks
223
Advertisement
Table of Contents
