Table of Contents
Advertisement
Routing
11. Configure source address information:
a. Click to expand Source address.
b. For Type, select one of the following:
n
n
n
n
n
12. Configure the destination address information:
a. Click to expand Destination address.
b. For Type, select one of the following:
n
n
n
n
n
n
13. Click Apply to save the configuration and apply the change.
Command line
IX20 User Guide
Zone: Matches the source IP address to the selected firewall zone. See
configuration
for more information about firewall zones.
Interface: Matches the source IP address to the selected interface's network
address.
IPv4 address: Matches the source IP address to the specified IP address or
network. Use the format IPv4_address[/netmask], or use any to match any IPv4
address.
IPv6 address: Matches the source IP address to the specified IP address or
network. Use the format IPv6_address[/prefix_length], or use any to match any
IPv6 address.
MAC address: Matches the source MAC address to the specified MAC address.
Zone: Matches the destination IP address to the selected firewall zone. See
configuration
for more information about firewall zones.
Interface: Matches the destination IP address to the selected interface's network
address.
IPv4 address: Matches the destination IP address to the specified IP address or
network. Use the format IPv4_address/[netmask], or use any to match any IPv4
address.
IPv6 address: Matches the destination IP address to the specified IP address or
network. Use the format IPv6_address/[prefix_length], or use any to match any IPv6
address.
Domain: Matches the destination IP address to the specified domain names. To
specify domains:
i. Click to expand Domains.
ii. Click the to add a domain.
iii. For Domain, type the domain name.
iv. Repeat to add additional domains.
Default route: Matches packets destined for the default route, excluding routes for
local networks.
IP routing
Firewall
Firewall
239
Advertisement
Table of Contents
