Table of Contents
Advertisement
Routing
i. Click to expand IPv4 > SureLink.
ii. Click Enable.
iii. For Interval, type a the amount of time to wait between connectivity tests. To
guarantee seamless internet access for VRRP+ purposes, SureLink tests should occur
more often than the default of 15 minutes.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take
the format number{w|d|h|m|s}. For example, to set Interval to five seconds, enter 5s.
iv. Click to expand Test targets > Test target.
v. Configure the test target. For example, to configure SureLink to verify internet
connectivity on the LAN by pinging my.devicecloud.com:
ii. For Ping host, type my.devicecloud.com.
11. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new VRRP instance, or edit an existing one. See
creating a new VRRP instance.
4. Enable VRRP+:
(config)> network vrrp VRRP_test vrrp_plus enable true
(config)>
IX20 User Guide
i. For Test Type, select Ping test.
Virtual Router Redundancy Protocol (VRRP)
Configure VRRP
for information about
271
Advertisement
Table of Contents
