Table of Contents
Advertisement
Wi-Fi
2. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Edit an existing Access point
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Show available access points:
(config)> network wifi ap ?
Additional Configuration
------------------------------------------------------------------------
-------
digi_ap
(config)>
4. Set the SSID for the appropriate access point:
(config)> network wifi ap digi_ap ssid my_SSID
(config)>
5. SSID broadcasting is enabled by default for the preconfigured access points. If SSID
broadcasting is disabled:
(config)> network wifi ap digi_ap ssid_broadcast true
(config)>
6. Set the security for the access point to wpa2:
(config network wifi ap new_AP)> encryption type wpa2
(config network wifi ap new_AP)>
7. (Optional) Determine whether to prevent clients that are connected to this access point from
communicating with each other:
(config)> network wifi ap digi_ap isolate_client true
(config)>
IX20 User Guide
Configure a Wi-Fi access point with enterprise security
Digi AP
211
Advertisement
Table of Contents
