Table of Contents
Advertisement
Wi-Fi
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the channel for the radio:
a. Determine the band for the radio:
(config)> network wifi radio phy0 band
2400mhz
(config)>
b. Set the channel for the Wi-Fi radio:
(config)> network wifi radio phy0 2400mhz channel value
(config)>
where value is:
n
n
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX20 User Guide
For 2.4 GHz:
1 through 11
l
auto
l
For 5 GHz:
36
l
40
l
44
l
48
l
auto
l
Configure the Wi-Fi radio's channel
188
Advertisement
Table of Contents
