Digi IX20-WAG4 User Manual page 668

Table of Contents

Advertisement

Firewall
v. For Protocol, select the IP protocol matching criteria for this rule.
vi. For Source port, type the port, or any, as a source traffic matching criteria.
vii. For Destination port, type the port, or any, as a destination traffic matching criteria.
viii. Click to expand Source address and select the Type:
ix. Click to expand Destination address and select the Type:
Repeat to add a new rule. Up to 30 rules can be configured.
10. Click Apply to save the configuration and apply the change.
  Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a binding:
(config)> add firewall qos end
(config firewall qos 2)>
New binding are enabled by default. To disable:
IX20 User Guide
Any: Source traffic from any address will be matched.
n
Interface: Only traffic from the selected Interface will be matched.
n
IPv4 address: Only traffic from the IP address typed in IPv4 address will be
n
matched. Use the format IPv4_address[/netmask], or use any to match any
IPv4 address.
IPv6 address: Only traffic from the IP address typed in IPv6 address will be
n
matched. Use the format IPv6_address[/prefix_length], or use any to match
any IPv6 address.
MAC address: Only traffic from the MAC address typed in MAC address will be
n
matched.
Any: Traffic destined for anywhere will be matched.
n
Interface: Only traffic destined for the selected Interface will be matched.
n
IPv4 address: Only traffic destined for the IP address typed in IPv4 address
n
will be matched. Use the format IPv4_address[/netmask], or use any to match
any IPv4 address.
IPv6 address: Only traffic destined for the IP address typed in IPv6 address
n
will be matched. Use the format IPv6_address[/prefix_length], or use any to
match any IPv6 address.
Configure Quality of Service options
668

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ix20

Table of Contents