Table of Contents
Advertisement
Services
3. Click System > Time
4. (Optional) For Timezone, select either UTC or select the location nearest to your current
location to set the timezone for your IX20 device. The default is UTC.
5. (Optional) Add upstream NTP servers that the device will use to synchronize its time. The
default setting is time.devicecloud.com.
To change the default value of the NTP server:
n
a. Click NTP servers.
b. For Server, type a new server name.
To add an NTP server:
n
a. Click NTP servers.
b. For Add Server, click .
c. For Server, enter the hostname of the upstream NTP server that the device will use
d. Click to add additional NTP servers. If multiple servers are included, servers are
Note
This list is synchronized with the list of servers included with NTP server configuration,
and changes made to one will be reflected in the other. See
server
for more information about NTP server configuration.
6. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) Set the timezone for the location of your IX20 device. The default is UTC.
IX20 User Guide
to synchronize its time.
tried in the order listed until one succeeds.
System time
Configure the device as an NTP
493
Advertisement
Table of Contents
