Table of Contents
Advertisement
Virtual Private Networks (VPN)
Home agent registration lifetime. This is provided by your cellular carrier.
n
The local network interfaces that will be advertised on NEMO.
n
Additional configuration items
The home agent Software Parameter Index (SPI).
n
Path MTU discovery.
n
Path MTU discovery is enabled by default. If it is disabled, identify the MTU.
Care of address: the local network interface that is used to communicate with the peer.
n
If set to Interface, identify the local interface to be used. Generally, this will be the
l
Wirelesss WAN (Modem).
If set to IP address, enter the IP address.
l
The local network of the GRE endpoint negotiated by NEMO.
n
If the local network is set to Interface, identify the local interface to be used.
l
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click VPN > NEMO.
The NEMO tunnel is enabled by default. To disable, click to toggle off Enable.
4. For Home IP address, type the IPv4 address of the NEMO virtual network interface.
5. For Zone, select the firewall zone for the NEMO tunnel.
6. For Home agent server IP address, type the IPv4 address of the NEMO home agent. This is
provided by your cellular carrier.
7. For Key, type the key used to authenticate to the home agent. This is provided by your cellular
carrier.
8. For Home agent SPI, type the Security Parameter Index (SPI) value, which is used in the
authentication extension when registering. This should be normally left at the default setting
of 256 unless your service provider indicates a different value.
IX20 User Guide
NEMO
390
Advertisement
Table of Contents
