Table of Contents
Advertisement
Routing
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a new Dynamic DNS instance. For example, to add an instance named new_ddns_
instance:
(config)> add network ddns new_ddns_instance
(config network ddns new_ddns_instance)>
New Dynamic DNS instances are enabled by default. To disable:
(config network ddns new_ddns_instance)> enable false
(config network ddns new_ddns_instance)>
4. Set the interface for the Dynamic DNS instance:
a. Use the ? to determine available interfaces:
(config network ddns new_ddns_instance)> interface ?
Interface: The network interface from which to obtain the IP address
to register with the dynamic DNS service.
Format:
defaultip
defaultlinklocal
eth1
eth2
loopback
Current value:
(config network ddns new_ddns_instance)> interface
b. Set the interface. For example:
(config network ddns new_ddns_instance)> interface eth1
(config network ddns new_ddns_instance)>
5. Set the Dynamic DNS provider service:
a. Use the ? to determine available services:
(config network ddns new_ddns_instance)> service ?
Service: The provider of the dynamic DNS service.
Format:
custom
IX20 User Guide
Dynamic DNS
261
Advertisement
Table of Contents
