Table of Contents
Advertisement
Applications
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a script:
(config)> add system schedule script end
(config system schedule script 0)>
Scheduled scripts are enabled by default. To disable:
(config system schedule script 0)> enable false
(config system schedule script 0)>
4. (Optional) Provide a label for the script.
(config system schedule script 0)> label value
(config system schedule script 0)>
where value is any string. if spaces are used, enclose value within double quotes.
5. Set the mode that will be used to run the script:
(config system schedule script 0)> when mode
(config system schedule script 0)>
where mode is one of the following:
boot: The script will run once each time the device boots.
n
l
interval: The script will start running at the specified interval, within 30 seconds after
n
the configuration change is saved. If interval is selected:
IX20 User Guide
If boot is selected, set the action that will be taken when the script completes:
(config system schedule script 0)> exit_action action
(config system schedule script 0)>
where action is one of the following:
none: Action taken when the script exits.
o
restart: Runs the script repeatedly.
o
reboot: The device will reboot when the script completes.
o
Configure scripts to run automatically
526
Advertisement
Table of Contents
