Table of Contents
Advertisement
Interfaces
The TFTP server name.
n
The filepath and name of the bootfile on the TFTP server.
n
Custom DHCP options. See
n
options.
Static leases. See
n
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Click to expand an existing LAN, or create a new LAN. See
5. Click to expand IPv4 > DHCP server.
6. Enable the DHCP server.
7. (Optional) For Lease time, type the amount of time that a DHCP lease is valid.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Lease time to ten minutes, enter 10m or 600s.
The default is 12 hours.
8. (Optional) For Lease range start and Lease range end, type the lowest and highest IP address
that the DHCP server will assign to a client. This value represents the low order byte of the
address (the final triplet in an IPv4 address, for example, 192.168.2.xxx). The remainder of the
IP address will be based on the LAN's static IP address as defined in the Address field.
Allowed values are between 1 and 254, and the default is 100 for Lease range start and 250
for Lease range end.
9. Optional DHCP server settings:
IX20 User Guide
Configure DHCP options
Map static IP addresses to hosts
Local Area Networks (LANs)
for information about custom DHCP
for information about static leases.
Configure a
LAN.
141
Advertisement
Table of Contents
