Table of Contents
Advertisement
User authentication
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication.
4. Click to disable Allow shell.
Note
If shell access is disabled, re-enabling it will erase the device's configuration and perform
a factory reset.
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
IX20 User Guide
Disable shell access
629
Advertisement
Table of Contents
