Table of Contents
Advertisement
Interfaces
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new WAN or edit an existing one:
To create a new WAN named my_wan:
n
(config)> add network interface my_wan
(config network interface my_wan)>
To edit an existing WAN named my_wan, change to the my_wan node in the
n
configuration schema:
(config)> network interface my_wan
(config network interface my_wan)>
4. Set the appropriate firewall zone:
(config network interface my_wan)> zone zone
(config network interface my_wan)>
See
Firewall configuration
5. Select an Ethernet device, a Wi-Fi device, or a bridge. See
bridging.
a. Enter device ? to view available devices and the proper syntax.
(config network interface my_wan)> device ?
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/loopback
/network/bridge/lan
/network/wireless/ap/digi_ap
Current value:
(config network interface my_wan)> device
b. Set the device for the LAN:
(config network interface my_wan)> device device
(config network interface my_wan)>
6. Configure IPv4 settings:
IPv4 support is enabled by default. To disable:
n
(config network interface my_wan)> ipv4 enable false
(config network interface my_wan)>
IX20 User Guide
for further information.
Wide Area Networks (WANs)
Bridging
for more information about
111
Advertisement
Table of Contents
