Digi IX20-WAG4 User Manual page 770

Diagnostics
2. Use show event
> show event
Timestamp
---------------- ------- --------- --------------------------------------
-----
Nov 26 21:42:37
intf=eth1~type=ethernet~rx=11332435~tx=5038762
Nov 26 21:42:35
+0000~uptime=3 hours, 0 minutes, 48 seconds
...
>
3. (Optional) Use the show event number num command to limit the number of lines that are
displayed. For example, to limit the event list to the most recent ten lines:
> show event number 10
Timestamp
---------------- ------- --------- --------------------------------------
-----
Nov 26 21:42:37
intf=eth1~type=ethernet~rx=11332435~tx=5038762
Nov 26 21:42:35
+0000~uptime=3 hours, 0 minutes, 48 seconds
...
>
4. (Optional) Use the show event table value command to limit the number of lines that are
displayed. Allowed values are error, info, and status. For example, to limit the event list to
only info messages:
> show event table info
Timestamp
---------------- ------- --------- --------------------------------------
-----
Nov 26 22:01:26
name=admin~service=cli~state=opened~remote=192.168.1.2
Nov 26 22:01:25
name=admin~service=cli~state=closed~remote=192.168.1.2
...
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX20 User Guide
at the Admin CLI prompt:
Type Category
status stat
status system
Type Category
status stat
status system
Type Category
info user
info user
View system and event logs
Message
local_time=Thu, 08 Aug 2019 21:42:35
Message
local_time=Thu, 08 Aug 2019 21:42:35
Message
770