Table of Contents
Advertisement
Wi-Fi
a. Click Configuration > Network > Interfaces.
b. For Add interface, type a name for the LAN and click .
c. For Zone, select LAN2_isolation_zone.
d. For Device, select the new Wi-Fi access point.
e. Click to expand IPv4.
f. For Address, type an IP address and subnet for the LAN.
g. Click to expand DHCP server.
h. Enable the DHCP server.
6. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure a new access point:
a. Create a new access point:
(config)> add network wifi ap new_AP
(config network wifi ap new_AP)>
New access points are enabled by default.
b. Set the SSID for the Wi-Fi access point. Up to 32 characters are allowed.
(config network wifi ap new_AP)> ssid my_SSID
(config network wifi ap new_AP)>
c. Set the security for the access point:
(config network wifi ap new_AP)> encryption type value
(config network wifi ap new_AP)>
where value is one of:
IX20 User Guide
Isolate Wi-Fi clients
217
Advertisement
Table of Contents
