Table of Contents
Advertisement
Serial port
7. If Login, Remote Access, or Modbus is selected for Mode:
a. Click to expand Serial Settings.
b. For Baud rate, select the baud rate used by the device to which you want to connect.
c. For Data bits, select the number of data bits used by the device to which you want to
connect.
d. For Parity, select the type of parity used by the device to which you want to connect.
e. For Stop bits, select the number of stop bits used by the device to which you want to
connect.
f. For Flow control, select the type of flow control used by the device to which you want to
connect.
8. (Optional) If Remote Access is selected for Mode:
a. Click to expand Service Settings.
All service settings are disabled by default. Click available options to toggle them to
enabled, and set the IP ports as appropriate.
b. Click to expand Session Settings.
c. Enable Exclusive access to limit access to the serial port to a single active session.
d. For Escape sequence, type the characters used to start an escape sequence. If no
characters are defined, the escape sequence is disabled. The default is ~b.
e. For History size, type or select the number of bytes of output from the serial port that are
written to buffer. These bytes are redisplayed when a user connects to the serial port. The
default is 4000 bytes.
f. For Idle timeout, type the amount of time to wait before disconnecting due to user
inactivity.
1. Click to expand Monitor Settings.
IX20 User Guide
Configure the serial port
169
Advertisement
Table of Contents
