Table of Contents
Advertisement
Services
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a location source:
(config)> add service location source end
(config service location source 1)>
4. (Optional) Set a label for this location source:
(config service location source 1)> label "label"
(config service location source 1)>
5. Set the type of location source to server:
(config service location source 1)> type server
(config service location source 1)>
6. Set the UDP port that will receive incoming location messages.
(config service location source 1)> server port port
(config service location source 1)>
7. Click Access control list to configure access control:
To limit access to specified IPv4 addresses and networks:
n
(config)> add service location source 1 acl address end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add service location source 1 acl address6 end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
IX20 User Guide
A single IP address or host name.
A network designation in CIDR notation, for example, 192.168.1.0/24.
any: No limit to IPv4 addresses that can access the location server UDP port.
A single IP address or host name.
A network designation in CIDR notation, for example, 2001:db8::/48.
any: No limit to IPv6 addresses that can access the location server UDP port.
Location information
454
Advertisement
Table of Contents
