Table of Contents
Advertisement
Firewall
To enable the Inbound binding:
n
(config)> firewall qos 1 enable true
(config)>
4. Set the interface for the binding. Use the index number of the binding; for example, to set the
interface for the Outbound binding:
a. Use the ? to determine available interfaces:
(config)> firewall qos 0 interface ?
Interface: The network interface.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config)> firewall qos 0 interface
b. Set the interface. For example:
(config)> firewall qos 0 interface /network/interface/eth1
(config)>
5. Examine the remaining default settings and modify as appropriate for your network.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Create a new binding
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX20 User Guide
Configure Quality of Service options
665
Advertisement
Table of Contents
