Table of Contents
Advertisement
Wi-Fi
3. Click Network > WiFi.
4. For Tx power percentage, type or select the appropriate percentage for the Wi-Fi radio's
transmit power.
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the transmit power percentage for the radio:
(config)> network wifi radio phy0 tx_power value
(config)>
where value is any integer between 1 and 100 and represents the percentage of transmit power
that the Wi-Fi module should use.
IX20 User Guide
Configure the Wi-Fi radio's transmit power
193
Advertisement
Table of Contents
