Show Openvpn Server Status And Statistics - Digi IX20-WAG4 User Manual

Virtual Private Networks (VPN)
12. Save the configuration and apply the change:
(config vpn openvpn client openvpn_client1 connection_monitor target 0)>
save
Configuration saved.
>
13. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show OpenVPN server status and statistics

You can view status and statistics for OpenVPN servers from either the web interface or the command
line:

WebUI
1. Log into the IX20 WebUI as a user with Admin access.
2. On the menu, select Status > OpenVPN > Servers.
The OpenVPN Servers page appears.
3. To view configuration details about an OpenVPN server, click the  (configuration) icon in the
upper right of the OpenVPN server's status pane.

Command line
1. Log into the IX20 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured OpenVPN servers, type the following at the prompt:
> show openvpn server all
Server
---------------
OpenVPN_server1
OpenVPN_server2
>
IX20 User Guide
For example, to set interface_timeout to ten minutes, enter either 10m or
600s:
(config vpn openvpn client openvpn_client1 connection_monitor
target 0)> interface_timeout 600s
(config vpn openvpn client openvpn_client1 connection_monitor
target 0)>
The default is 60 seconds.
Enable Type
------ ----
true tun
false tun
Zone IP Address
-------- ---------------
internal 192.168.30.1/24
internal 192.168.40.1/24
OpenVPN
Port
----
1194
1194
365