Digi IX20-WAG4 User Manual page 768

Diagnostics
5. Click  to download the system log.

Command line
1. Log into the IX20 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use show log
> show log
Timestamp
--------------
----
Nov 26 21:54:34
Nov 26 21:54:35
...
>
3. (Optional) Use the show log number num command to limit the number of lines that are
displayed. For example, to limit the log to the most recent ten lines:
> show log number 10
Timestamp
--------------
----
Nov 26 21:54:34
Nov 26 21:54:35
...
>
4. (Optional) Use the show log filter value command to limit the number of lines that are
displayed. Allowed values are critical, warning, info, and debug. For example, to limit the
event list to only info messages:
> show log filter info
Timestamp
---------------- ------- --------- --------------------------------------
-----
Nov 26 22:01:26
name=admin~service=cli~state=opened~remote=192.168.1.2
Nov 26 22:01:25
name=admin~service=cli~state=closed~remote=192.168.1.2
...
>
IX20 User Guide
at the Admin CLI prompt:
Message
---------------------------------------------------------
IX20 netifd: Interface 'interface_wan' is setting up now
IX20 firewalld[621]: reloading status
Message
---------------------------------------------------------
IX20 netifd: Interface 'interface_wan' is setting up now
IX20 firewalld[621]: reloading status
Type Category
info user
info user
View system and event logs
Message
768