Table of Contents
Advertisement
Interfaces
3. Click Network > Virtual LAN.
4. Type a name for the VLAN and click .
5. Select the Device.
6. Type or select a unique numeric ID for the VLAN ID.
7. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add the VLAN:
(config)> add network vlan name
(config)>
4. Set the device to be used by the VLAN:
a. View a list of available devices:
(config network vlan vlan1)> device ?
Device: The Ethernet device to use for this virtual LAN
Format:
/network/device/eth1
/network/device/eth2
/network/device/loopback
/network/vlan/vlan1
/network/bridge/lan
/network/wireless/ap/digi_ap
Current value:
IX20 User Guide
Local Area Networks (LANs)
157
Advertisement
Table of Contents
