Table of Contents
Advertisement
Interfaces
a. Click to expand Advanced settings.
b. For Gateway, select either:
n
n
n
The default is Automatic.
c. For MTU,
n
n
n
The default is Automatic.
d. For Domain name suffix, type the domain name that should be appended to host names.
e. For Primary and Secondary DNS, Primary and Secondary NTP server, and Primary and
Secondary WINS server, select either:
n
n
n
f. For Bootfile name, type the relative path and file name of the bootfile on the TFTP server.
g. For TFTP server name, type the IP address or host name of the TFTP server.
10. See
Configure DHCP options
11. See
Map static IP addresses to hosts
12. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the DHCP server for an existing LAN. For example, to enable the DHCP server for a LAN
named my_lan:
IX20 User Guide
None: No gateway is broadcast by the DHCP server. Client destinations must be
resolvable without a gateway.
Automatic: Broadcasts the IX20 device's gateway.
Custom: Allows you to identify the IP address of a Custom gateway to be
broadcast.
None: An MTU of length 0 is broadcast. This is not recommended.
Automatic: No MTU is broadcast and clients will determine their own MTU.
Custom: Allows you to identify a Custom MTU to be broadcast.
None: No server is broadcast.
Automatic: Broadcasts the IX20 device's server.
Custom: Allows you to identify the IP address of the server.
for information about Custom DHCP options.
for information about Static leases.
Local Area Networks (LANs)
142
Advertisement
Table of Contents
