Table of Contents
Advertisement
Configuration and
management
special character.
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set a new password for the admin user. The password must be at least eight characters long
and must contain at least one uppercase letter, one lowercase letter, one number, and one
special character.
(config)> auth user admin password new-password
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Reset default SSID and pre-shared key for the preconfigured Wi-
Fi access point
For the Wi-Fi enabled IX20W device, by default, the SSID and pre-shared key for the preconfigured Wi-
Fi access point are:
IX20 User Guide
Reset default SSID and pre-shared key for the preconfigured Wi-Fi access
point
47
Advertisement
Table of Contents
