Table of Contents
Advertisement
Routing
3. Click Network > Routes > Policy-based routing.
4. Click the to add a new route policy.
5. For Label, enter Route through cellular.
6. For Interface, select Modem.
7. Configure the source address:
a. Click to expand Source address.
b. For Type, select Zone.
c. For Zone, select Internal.
8. Configure the destination address:
a. Click to expand Destination address.
b. For Type, select IPv4 address.
c. For IPv4 address, type the IP address that will be the destination for outgoing traffic
routed through the WWAN interface. In the above example, this is 241.236.162.59.
9. Click Apply to save the configuration and apply the change.
IX20 User Guide
IP routing
246
Advertisement
Table of Contents
