L2Tpv3; Configure An L2Tpv3 Tunnel - Digi IX20-WAG4 User Manual

Table of Contents

Advertisement

Virtual Private Networks (VPN)
test NEMO Status
----------------
Enabled
Status
Home Agent
Care of Address
Interface
GRE Tunnel
Metric
MTU
Lifetime (Actual)
Local Network
-------------
lan1
LAN2
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

L2TPv3

Your IX20 device supports Layer 2 Tunnelling Protocol Version 3 (L2TPv3) static unmanaged Ethernet
tunnels.

Configure an L2TPv3 tunnel

Your IX20 device supports Layer 2 Tunnelling Protocol Version 3 (L2TPv3) static unmanaged Ethernet
tunnels.
Required configuration items
A name for the L2TPv3 tunnel.
n
Enable the tunnel.
n
The remote endpoint IP address.
n
The local endpoint IP address.
n
The session ID.
n
The peer session ID.
n
Additional configuration items
Encapsulation type. If UDP is selected:
n
The ID for the tunnel.
l
The ID of the peer's tunnel.
l
Determine whether to enable UDP checksum.
l
IX20 User Guide
: true
: up
: 4.3.2.1
: 10.10.10.1
: modem
: 10.10.10.1 === 4.3.2.1
: 255
: 1476
: 600
Subnet
Status
--------------
----------
192.168.2.1/24
Advertized
192.168.3.1/24
Advertized
L2TPv3
396

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ix20

Table of Contents