Table of Contents
Advertisement
Interfaces
5. If Manual or Manual/Automatic are selected for Carrier section mode, enter the Network
PLMN ID.
Note
You can use the
and determine their PLMN ID. See
6. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, type:
(config)> network interface modem modem operator_mode value
(config)>
where value is one of:
automatic—The device automatically selects the carrier based on your SIM and cellular
n
network status.
manual—The device will only connect to the carrier identified in the Network PLMN ID.
n
If the carrier is not available, no cellular connection will be established.
IX20 User Guide
modem scan
command at the Admin CLI to scan for available carriers
Scan for available cellular carriers
Wide Area Networks (WANs)
for details.
100
Advertisement
Table of Contents
