Table of Contents
Advertisement
System administration
3. In the Erase configuration section, click ERASE.
4. Click CONFIRM.
5. After resetting the device:
a. Connect to the IX20 by using the serial port or by using an Ethernet cable to connect the
IX20 ETH2 port to your PC.
b. Log into the IX20:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
For Wi-Fi enabled models, when you first log into the WebUI or the command line, you will
be required the change the SSID and pre-shared key (password) for the preconfigured Wi-
Fi access point before you can save any configuration changes. See
pre-shared key for the preconfigured Wi-Fi access point
c. (Optional) Reset the default password for the admin account. See
password for the admin user
Command line
1. Log into the IX20 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the following:
> system factory-erase
3. After resetting the device:
a. Connect to the IX20 by using the serial port or by using an Ethernet cable to connect the
IX20 ETH2 port to your PC.
b. Log into the IX20:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
IX20 User Guide
Erase device configuration and reset to factory defaults
for further information.
Reset default SSID and
for instructions.
Change the default
702
Advertisement
Table of Contents
