Example: Route Traffic To A Specific Wan Interface Based On The Client Mac Address - Digi IX20-WAG4 User Manual

Routing
(config network route policy 0)> dst address 241.236.162.59
(config network route policy 0)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Example: Route traffic to a specific WAN interface based on the
client MAC address
This example routes all data from a certain client device through a cellular WAN based on the device's
MAC address, while all other client devices are routed through the Ethernet WAN.

WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX20 User Guide
IP routing
248