Table of Contents
Advertisement
Firewall
Repeat to add a new rule. Up to 30 rules can be configured.
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX20 User Guide
i. Use the ? to determine available interfaces:
(config network qos 2 policy 0 rule 0)> dst interface ?
Interface: Match the IP address with the specified
interface's network address.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config network qos 2 policy 0 rule 0)> dst interface
ii. Set the interface. For example:
(config network qos 2 policy 0 rule 0)> dst interface
/network/interface/eth1
(config network qos 2 policy 0 rule 0)>
address: Only traffic destined for the IP address typed in IPv4 address will be
n
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv4_address[/netmask], or any to match any
IPv4 address.
address6: Only traffic destined for the IP address typed in IPv6 address will be
n
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address6 value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv6_address[/prefix_length], or any to match
any IPv6 address.
Configure Quality of Service options
673
Advertisement
Table of Contents
