Digi IX20-WAG4 User Manual page 717

Table of Contents

Advertisement

System administration
4. Schedule system maintenance:
5. Configure the device to look for any updated modem firmware during the maintenance
window. If updated firmware is found, it will then be installed. The device will look for updated
firmware both on the local device and over the network, using either a WAN or cellular
connection.
system schedule maintenance modem_fw_update value
(config)>
where value is either true or false. yes or no, and 1 or 0 are also allowed.
6. (Optional) Configure automated checking for device firmware updates:
a. Device firmware update check is enabled by default. This enables to automated
checking for device firmware updates. To disable:
(config)> system schedule maintenance firmware_update_check device
false
(config)>
b. Set how often automated checking for device firmware should take place:
(config)> system schedule maintenance frequency value
(config)>
where value is either daily, weekly, or monthly. daily is the default.
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
IX20 User Guide
If the duration length is set to any value other than to 0 or 24 hours, the
l
maintenance tasks will run at a random time during the time allotted for
the duration window.
If the duration length is set to one or more hours, the minutes field in the
l
start time is ignored and the duration window will begin at the beginning
of the specified hour.
ii. Configure the duration length (the amount of time that the maintenance tasks
will be run). If 0 is used, all scheduled tasks will begin at the start time, defined
in the previous step.
(config system schedule maintenance trigger 0)> length num
(config system schedule maintenance trigger 0)>
where num is any whole number between 0 and 24.
iii. Configure the frequency that the maintenance tasks should be run:
(config system schedule maintenance trigger 0)> frequency
value
(config system schedule maintenance trigger 0)>
where value is either daily or weekly. Daily is the default.
Schedule system maintenance tasks
717

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ix20

Table of Contents