Table of Contents
Advertisement
Routing
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create the route policy:
a. Add a new routing policy:
(config)> add network route policy end
(config network route policy 0)>
b. Set the label that will be used to identify this route policy:
(config network route policy 0)> label "Route through cellular"
(config network route policy 0)>
c. Set the interface:
(config network route policy 0)> interface /network/interface/modem
(config network route policy 0)>
d. Configure the source address:
i. Set the source type to zone:
(config network route policy 0)> src type zone
(config network route policy 0)>
ii. Set the zone to internal:
(config network route policy 0)> src zone internal
(config network route policy 0)>
e. Configure the destination address:
i. Set the destination to use an IPv4 address:
(config network route policy 0)> dst type address
(config network route policy 0)>
ii. Set the IP address that will be the destination for outgoing traffic routed through the
WWAN interface. In the above example, this is 241.236.162.59.
IX20 User Guide
IP routing
247
Advertisement
Table of Contents
