Table of Contents
Advertisement
Routing
(config network route policy 0)> dst mac MAC_address
(config network route policy 0)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Example: Dual WAN policy-based routing
This example routes traffic to a specific IP address to go through the cellular WWAN interface, while all
other traffic uses the Ethernet WAN interface.
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX20 User Guide
IP routing
245
Advertisement
Table of Contents
