Table of Contents
Advertisement
Wi-Fi
Command line
Configure a new Access point
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new access point:
(config)> add network wifi ap new_AP
(config network wifi ap new_AP)>
New access points are enabled by default.
4. Set the SSID for the Wi-Fi access point. Up to 32 characters are allowed.
(config network wifi ap new_AP)> ssid my_SSID
(config network wifi ap new_AP)>
SSID broadcasting is enabled by default for new access points.
5. Set the security for the access point to wpa2:
(config network wifi ap new_AP)> encryption type wpa2
(config network wifi ap new_AP)>
6. (Optional) Determine whether to prevent clients that are connected to this access point from
communicating with each other:
(config)> network wifi ap digi_ap isolate_clients true
(config)>
See
Isolate Wi-Fi clients
access points from communicating with each other.
7. Configure one or more RADIUS servers:
a. Set the IP address of the RADIUS server:
(config network wifi ap new_AP)> encryption radius_servers 0 host IP_
address
(config network wifi ap new_AP)>
IX20 User Guide
Configure a Wi-Fi access point with enterprise security
for information about how to prevent clients connected to different
209
Advertisement
Table of Contents
