Routing
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Status > Routes.
The Network Routing window is displayed.
4. Click IPv4 Load Balance to view IPv4 load balancing.
5. Click IPv6 Load Balance to view IPv6 load balancing.
Command line
1. Log into the IX20 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type
> show route
Destination
Interface
------------------------
---
------------------------
default
10.1.14.25
/network/device/eth1
10.1.14.27
/network/device/eth1
10.1.25.0/24
/network/device/eth1
127.0.0.0/8
/network/device/loopback
fd00:2704::1
IX20 User Guide
show
route:
Gateway
------------------------
10.1.21.1
10.1.21.1
10.1.21.1
fe80::204:f3ff:fe80:e231
Show the routing table
Source
Metric
-----------
-------
1
10.1.21.99
1
10.1.21.99
1
10.1.21.99
1
127.0.0.1
1
257