Table of Contents
Advertisement
Services
6. Type the Username used to connect to the SNMP agent.
7. Type the Password used to connect to the SNMP agent.
8. (Optional) For Port, type the port number. The default is 161.
9. (Optional) Multicast DNS (mDNS) is disabled by default. mDNS is a protocol that resolves host
names in small networks that do not have a DNS server. To enable mDNS, click Enable mDNS.
10. (Optional) Select the Authentication type, either MD5 or SHA. The default is MD5.
11. (Optional) Type the Privacy passphrase. If not set, the password, entered above, is used.
12. (Optional) Select the Privacy protocol, either DES or AES. The default is DES.
13. (Optional) Click Enable version 2c access to enable read-only access to SNMP version 2c.
14. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the SNMP agent:
(config)> service snmp enable true
(config)>
4. Configure access control:
To limit access to specified IPv4 addresses and networks:
n
(config)> add service snmp acl address end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add service snmp acl address6 end value
(config)>
Where value can be:
IX20 User Guide
A single IP address or host name.
A network designation in CIDR notation, for example, 192.168.1.0/24.
any: No limit to IPv4 addresses that can access the SNMP service.
Simple Network Management Protocol (SNMP)
441
Advertisement
Table of Contents
