Table of Contents
Advertisement
Interfaces
(Optional) Repeat to add additional test targets.
9. Optional active recovery configuration parameters:
a. Move back two levels in the configuration by typing .. ..:
(config network interface my_wan ipv4 surelink target 0)> .. ..
(config network interface my_wan ipv4 surelink>
b. Set the Interval between connectivity tests:
(config network interface my_wan ipv4 surelink)> interval value
(config network interface my_wan ipv4 surelink>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set interval to ten minutes, enter either 10m or 600s:
IX20 User Guide
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config network interface my_wan ipv4 surelink target
0)> other_interface
ii. Set the interface. For example:
(config network interface my_wan ipv4 surelink target
0)> other_interface /network/interface/eth1
(config network interface my_wan ipv4 surelink target
0)>
o
Set the alternate interface's IP version. This allows you to determine the
alternate interface's status for a particular IP version.
(config network interface my_wan ipv4 surelink target 0)>
other_ip_version value
(config network interface my_wan ipv4 surelink target 0)>
where value is one of: any, both, ipv4, or ipv6.
Set the expected status of the alternate interface:
o
(config network interface my_wan ipv4 surelink target 0)>
other_status value
(config network interface my_wan ipv4 surelink target 0)>
where value is either up or down. For example, if other_status is set to down,
but the alternate interface is determined to be up, then this test will fail.
Wide Area Networks (WANs)
75
Advertisement
Table of Contents
