Table of Contents
Advertisement
3. Position draper header support (B) on windrower lift
linkage (A). Reinstall clevis pin (C).
NOTE:
To ensure that the pin doesn't snag the windrow, install the
clevis pin on the outboard side of the draper
header support.
4. Secure clevis pin (C) with hairpin (D).
5. Repeat Step
2, page 118
remaining draper header support.
5.2.2 Attaching D2 SP Series Draper Header
The windrower's lift linkage and center-link will need to be connected to the header.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator's seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Ensure that all bystanders have cleared the area.
1. Clear all bystanders from the area.
2. Shut down the engine, and remove the key from the ignition.
3. If the windrower was previously attached to an R216 Rotary
Disc Header, make sure to remove the forming shield (not
shown), including forming shield support brackets (A) and
hardware (B) from both legs. You can store the brackets
and hardware in the windrower tool box.
• For instructions on removing the R216 forming shield,
refer to
5.4.6 Removing Forming Shield from the
Windrower, page
197.
262175
ATTACHING HEADERS TO WINDROWER
to Step
4, page 119
to install the
Figure 5.50: Draper Header Support
A
B
Figure 5.51: Forming Shield bracket – R2 Series
119
A
B
C
Revision A
D
Advertisement
Table of Contents
