Table of Contents
Advertisement
ATTACHING HEADERS TO AND DETACHING HEADERS FROM WINDROWER
3. Position draper header support (B) on windrower lift
linkage (A). Reinstall clevis pin (C).
NOTE:
To ensure that the pin doesn't snag the windrow, install the
clevis pin on the outboard side of the draper
header support.
4. Secure clevis pin (C) with hairpin (D).
5. Repeat Step
2, page 129
remaining draper header support.
4.2.2 Attaching D2 SP Series Draper Header
The windrower's lift linkage and center-link will need to be connected to the header.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator's seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Ensure that all bystanders have cleared the area.
1. Shut down the engine, and remove the key from the ignition.
262171
to Step
4, page 130
to install the
Figure 4.41: Draper Header Support
130
A
B
C
Revision A
D
Advertisement
Table of Contents
Troubleshooting
