Table of Contents
Advertisement
Preparing Windrower to Tow a Header
The instructions in this section will prepare you to safely tow a header with the windrower.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.
1. Attach the header to the windrower. For instructions, refer
to
4.2.2 Attaching D2 SP Series Draper Header, page
2. Convert the header to transport mode. For instructions,
refer to header operator's manual.
3. Detach the header from the windrower. For instructions,
refer to
4.2.4 Detaching D2 SP Series Draper Header, page
143.
4. Remove hairpin (D) and clevis pin (C) securing header
support (B) to leg (A). Retain the pins.
5. Remove header support (B) from windrower lift leg (A).
6. Repeat the previous step for the opposite support.
7. Retract windrower transport to road mode. Refer to
Retracting Wheels – Narrow Transport, page
262171
OPERATION
130.
Figure 5.57: Windrower with Header
C
229.
Figure 5.58: Draper Header Support
219
A
D
B
Revision A
Advertisement
Table of Contents
Troubleshooting
