Do The Identification (Id) Run; Background Information - ABB ACS280 Firmware Manual

18 Start-up, ID run and use
Scalar mode is not recommended for permanent magnet motors.
5.
Set the nominal motor values:
•
Nominal power
•
Nominal current
•
Nominal voltage
•
Nominal frequency
•
Nominal speed
•
Nominal torque (optional)
•
Nominal cosphi (optional)
6.
Examine the direction of the motor.
If it is necessary, set the motor direction with the Phase order setting or
with the phase order of the motor cable.
7.
Motor control
In the
8.
Set the acceleration time and the deceleration time.
Note: The speed acceleration and deceleration ramp times are based on
the value in parameter
9.
Set the maximum and minimum speed or frequency. For more information,
see parameters
Maximum speed
10.
Tune the drive parameters to the application. You can use the Assistant
control panel (ACS-AP-x), or the Drive Composer PC tool with the drive.

Do the identification (ID) run



Background information

The drive automatically estimates motor characteristics using Standstill ID run
when the drive is started for the first time, and after any motor parameter
99 Motor data
(group
•
99.13 ID run requested
parameter
•
99.04 Motor control mode
parameter
In most applications there is no need to perform a separate ID run. Select the ID
run for demanding motor control connections. For example:
•
permanent magnet motor (PMSM) is used
•
drive operates near zero speed references, or
•
operation at torque range above the motor nominal torque, over a wide
speed range is needed.
,
view set the start and stop mode.
46.01 Speed scaling
30.11 Minimum speed
30.14 Maximum frequency
/
) is changed. This is valid when:
selection is
46.02 Frequency scaling
/
30.13 Minimum frequency
/
183
on page
Standstill
and
Vector
selection is .
.
30.12
and
.