ABB ACS280 Firmware Manual page 45

Jog Jog
Phase
cmd enable
0 - >1
14-15 x
0 - >1
15-16 1
16-17 1 1
1 - >0
17-18 0
Notes:
• Jogging is not available when the drive is in local control.
• Jogging cannot be enabled when the drive start command is on, or the drive
started when jogging is enabled. Starting the drive after the jog enable
switches off requires a fresh start command.
WARNING! If jogging is enabled and activated while the start command is
on, jogging will activate as soon as the start command switches off.
• If both jogging functions are activated, the one that was activated first has
priority.
• Jogging function can only be used in Speed control mode.
• The inching functions activated through fieldbus (
references and ramp times defined for jogging, but do not require the jog
enable signal.
Settings and diagnostics
20.25 Jogging enable
Parameters
135 20.27 Jogging 2 start source
),
22.43 Jogging 2 ref
jogging 156
(page
2 frequency ref
(page
Events: -
Start
Description
cmd
1 Drive follows the speed reference. As long as the start
command is on, the jog enable signal is ignored. If the
jog enable signal is on when the start command switches
off, jogging is enabled immediately.
0 Start command switches off. The drive starts to
decelerate along the selected deceleration ramp
(parameters
When the jog command switches on, the decelerating
drive adopts the deceleration ramp of the jogging
function.
0 Drive follows the jog reference.
0 Drive decelerates to zero speed along the deceleration
ramp of the jogging function.
(page
(page
152 23.20 Acc time jogging
(page ),
28.42 Jogging 1 frequency ref
),
176
).
23.11 23.15
... ).
06.01
134 20.26 Jogging 1 start source
),
135 22.42 Jogging 1 ref
),
(page
176
(page
Program features 45
bits 8...9) use the
(page
152
(page ),
156 23.21 Dec time
),
28.43 Jogging
), and