ABB ACS280 Firmware Manual page 272

272 Parameters
No. Name/Value
96
96 System
96.01 Language
not used
English
Chinese (Simplified,
PRC)
96.02 Pass code
0...99999999
96.03 Access levels status
Bit Name
0 End user
1 Service
2, 3 Reserved
5...10 Reserved
11 OEM access level 1
12 OEM access level 2
13 OEM access level 3
14 Parameter lock
15 Reserved
0b0000...0b1111
Description
Language selection; access levels; parameter save
and restore; control unit reboot; user parameter sets;
unit selection; parameter checksum calculation; user
lock.
Selects the language of the parameter interface and
other displayed information when viewed on the
control panel.
Notes:
• Not all languages listed below are necessarily
supported.
• This parameter does not affect the languages
visible in the Drive composer PC tool. (Those are
specified under View – Settings – Drive default
language.)
Select a language.
English.
Simplified Chinese.
Pass codes can be entered into this parameter to
activate further access levels, for example additional
parameters, parameter lock, etc. See parameter
Access levels status
.
Entering "358" toggles the parameter lock, which
prevents the changing of all other parameters
through the control panel or the Drive composer PC
tool.
Entering the user pass code (by default, "10000000")
96.100
enables parameters
used to define a new user pass code and to select the
actions that are to be prevented.
Entering an invalid pass code will close the user lock if
open, ie. hide parameters
entering the code, check that the parameters are in
fact hidden.
Note: We recommend that you change the default
user pass code.
User lock
See also section
Pass code.
Shows which access levels have been activated by
pass codes entered into parameter
Active access levels.
96.03
96.102
... , which can be
96.100 96.102
... . After
86
(page ).
96.02 Pass code
Default
FbEq 16
not used
0
1033
2052
0
-
0b0000
.
-