ABB ACS280 Firmware Manual page 154

154 Parameters
No. Name/Value
22.73 Motor potentiometer
up source
Not used
Used
DI1
DI2
DI3
DI4
Supervision 1
Supervision 2
Supervision 3
Supervision 4
Supervision 5
Supervision 6
Other [bit]
22.74 Motor potentiometer
down source
22.75 Motor potentiometer
ramp time
0.0...3600.0 s
22.76 Motor potentiometer
min value
-32768.00... 32767.00
22.77 Motor potentiometer
max value
-32768.00... 32767.00
22.80 Motor potentiometer
ref act
-32768.00... 32767.00
Description
Selects the source of motor potentiometer up signal.
0 = No change
1 = Increase motor potentiometer value. (If both the
up and down sources are on, the potentiometer value
will not change.)
0.
1.
10.02 DI delayed status
Digital input DI1 (
10.02 DI delayed status
Digital input DI2 (
10.02 DI delayed status
Digital input DI3 (
10.02 DI delayed status
Digital input DI4 (
32.01 Supervision status
Bit 0 of
32.01 Supervision status
Bit 1 of
32.01 Supervision status
Bit 2 of
Bit 3 of 32.01 Supervision status
32.01 Supervision status
Bit 4 of
32.01 Supervision status
Bit 5 of
Terms and abbreviations
Source selection (see
Selects the source of motor potentiometer down
signal.
0 = No change
1 = Decrease motor potentiometer value. (If both the
up and down sources are on, the potentiometer value
will not change.)
For the selections, see parameter
Defines the change rate of the motor potentiometer.
This parameter specifies the time required for the
motor potentiometer to change from minimum
22.76
(parameter ) to maximum (parameter
same change rate applies in both directions.
Motor potentiometer change time.
Defines the minimum value of the motor
potentiometer.
Note: If vector control mode is used, the value of this
parameter must be changed.
Motor potentiometer minimum.
Defines the maximum value of the motor
potentiometer.
Note: If vector control mode is used, the value of this
parameter must be changed.
Motor potentiometer maximum.
Shows the output of the motor potentiometer
function. (The motor potentiometer is configured
22.71
using parameters
This parameter is read-only.
Value of motor potentiometer.
, bit 0).
, bit 1).
, bit 2).
, bit 3).
.
.
.
.
.
.
22.73
.
22.77
22.74
... .)
Default
FbEq 16
not used
0
1
2
3
4
5
24
25
26
27
28
29
). -
not used
40.0 s
). The
1 = 1 s
-50.00
1 = 1
50.00
1 = 1
-
1 = 1