ABB ACS280 Firmware Manual page 134
Coldplate drives
Hide thumbs
Also See for ACS280:
- Quick installation and start-up manual (2 pages) ,
- Hardware manual (144 pages)
Table of Contents
Advertisement
134 Parameters
No.
Name/Value
20.22
Enable to rotate
Not used
Used
DI1
DI2
DI3
DI4
Supervision 1
Supervision 2
Supervision 3
Supervision 4
Supervision 5
Supervision 6
Other [bit]
20.25
Jogging enable
Not used
Used
DI1
DI2
DI3
DI4
Supervision 1
Supervision 2
Supervision 3
Description
Setting this parameter to 0 stops motor rotating but
does not affect any other conditions for rotating.
Setting the parameter back to 1 starts motor rotating
again.
This parameter can be used for example with a signal
from some external equipment to prevent the motor
rotating before the equipment is ready.
When this parameter is 0 (rotating of the motor is
disabled), bit 13 of parameter
1
is set to 0.
0 (always off).
1 (always on).
10.02 DI delayed status
Digital input DI1 (
10.02 DI delayed status
Digital input DI2 (
10.02 DI delayed status
Digital input DI3 (
10.02 DI delayed status
Digital input DI4 (
32.01 Supervision status
Bit 0 of
32.01 Supervision status
Bit 1 of
32.01 Supervision status
Bit 2 of
32.01 Supervision status
Bit 3 of
32.01 Supervision status
Bit 4 of
32.01 Supervision status
Bit 5 of
Terms and abbreviations
Source selection (see
Selects the source for a jog enable signal.
(The sources for jogging activation signals are
selected by parameters
20.27 Jogging 2 start source
and
1 = Jogging is enabled.
0 = Jogging is disabled.
Notes:
• Jogging is supported in vector control mode only.
• Jogging can be enabled only when no start
command from an external control location is
active. On the other hand, if jogging is already
enabled, the drive cannot be started from an
external control location (apart from inching
commands through fieldbus).
Rush control
See section
0.
1.
10.02 DI delayed status
Digital input DI1 (
10.02 DI delayed status
Digital input DI2 (
10.02 DI delayed status
Digital input DI3 (
10.02 DI delayed status
Digital input DI4 (
32.01 Supervision status
Bit 0 of
32.01 Supervision status
Bit 1 of
32.01 Supervision status
Bit 2 of
06.16 Drive status word
, bit 0).
, bit 1).
, bit 2).
, bit 3).
.
.
.
.
.
.
20.26 Jogging 1 start source
.)
43
on page
.
, bit 0).
, bit 1).
, bit 2).
, bit 3).
.
.
.
Default
FbEq 16
Selected
0
1
2
3
4
5
24
25
26
27
28
29
).
-
not used
0
1
2
3
4
5
24
25
26
Advertisement
Table of Contents
