Terms And Abbreviations - ABB ACS280 Firmware Manual

Terms and abbreviations

Term/abbreviation
ACS-AP-x
ACS-BP-S
AI
AO
AsynM
BCBL-01
Capacitor bank
Control board
DC link
DC link capacitors
DI
DO
Drive
EFB
Frame (size)
ID run
Hexadecimal
IGBT
Intermediate circuit
Inverter
I/O
LSW
Macro
Explanation
Assistant control panel, advanced operator keypad for
communication with the drive.
The ACS280 supports:
• ACS-AP-S assistant control panel
• ACS-AP-W assistant control panel with Bluetooth
• ACS-BP-S basic control panel
Basic control panel, basic operator keypad for
communication with the drive.
Analog input; interface for analog input signals
Analog output; interface for analog output signals
Asynchronous motor
Optional USB to RJ45 cable
DC link capacitors
See
Circuit board in which the control program runs
DC circuit between rectifier and inverter
Energy storage which stabilizes the intermediate circuit DC
voltage
Digital input; interface for digital input signals
Digital output; interface for digital output signals
Frequency converter for controlling AC motors
Embedded fieldbus
Refers to the drive physical size, for example R1. The type
designation label attached to the drive shows the frame of
the drive, see the hardware manual of the drive.
Motor identification run. During the identification run, the
drive will identify the characteristics of the motor for
optimum motor control.
Describes binary numbers using a numbering system that
has 16 sequential numbers as base units. The hexadecimal
numbers are 0-9 and the letters A-F.
Insulated gate bipolar transistor
DC link
See .
Converts direct current and voltage to alternating current
and voltage.
Input/Output
Least significant word
Pre-defined default values of parameters in a drive control
program. Each macro is intended for a specific application.
Default control connection
See chapter
Introduction to the manual 13
.
.