ABB ACS280 Firmware Manual page 222

222 Parameters
No. Name/Value
37.15 ULC speed table point
5
-30000.0...30000.0
rpm
37.16 ULC frequency table
point 1
-598.00...598.00 Hz
37.17 ULC frequency table
point 2
-598.00...598.00 Hz
37.18 ULC frequency table
point 3
-598.00...598.00 Hz
37.19 ULC frequency table
point 4
-598.00...598.00 Hz
37.20 ULC frequency table
point 5
-598.00...598.00 Hz
37.21 ULC underload point 1
-1600.0...1600.0%
Description
Defines the fifth speed point.
37.11 ULC speed table point 1
See parameter
Speed.
Defines the first of the five frequency points on the X-
axis of the user load curve.
The values of the parameters must satisfy: -500.0 Hz
37.16 ULC frequency table point 1
<
frequency table point 2
point 3 37.19 ULC frequency table point 4
<
ULC frequency table point 5
Frequency points are used if parameter
control mode
is set to
Hz.
The five points must be in order from lowest to
highest. The points are defined as positive values, but
the range is
symmetrically effective also in the negative direction.
The
monitoring is not active outside these two areas.
Frequency.
Defines the second frequency point.
37.16 ULC frequency table point 1
See parameter
Frequency.
Defines the third frequency point.
37.16 ULC frequency table point 1
See parameter
Frequency.
Defines the fourth frequency point.
37.16 ULC frequency table point 1
See parameter
Frequency.
Defines the fifth frequency point.
37.16 ULC frequency table point 1
See parameter
Frequency.
Defines the first of the five points on the Y-axis that
together with the corresponding point on the X-axis
37.11 ULC speed table point 1
(
table point 5 37.15 ULC speed table point 5
or
ULC frequency table point 5
(lower) curve.
The following conditions must be fulfilled:
37.21 ULC underload point 1
•
point 1
37.22 ULC underload point 2
•
point 2
37.23 ULC underload point 3
•
point 3
37.24 ULC underload point 4
•
point 4
37.25 ULC underload point 5
•
point 5
Underload point.
.
37.17 ULC
<
37.18 ULC frequency table
<
<
< 500.0 Hz.
99.04 Motor
Scalar
and the reference unit is
37.15 ULC speed
...
) define the underload
37.31 ULC overload
<=
37.32 ULC overload
<=
37.33 ULC overload
<=
37.34 ULC overload
<=
37.35 ULC overload
<=
Default
FbEq 16
1800.0 rpm
1 = 1 rpm
5.0 Hz
37.20
1 = 1 Hz
25.0 Hz
.
1 = 1 Hz
43.0 Hz
.
1 = 1 Hz
50.0 Hz
.
1 = 1 Hz
60.0 Hz
.
1 = 1 Hz
10.0%
37.15
...
1 = 1%