Product Identification; Name Plates; Warning Signs On The System - ABB ProKiln GAC400 Operating Instruction

34 ProKiln GAC400 PROBE GAS SAMPLING SYSTEM | OI/GAC400-EN REV. A

4 Product identification

Name plates

Note
The name plates displayed are examples. The device
identification plates affixed to the device can differ from this
representation.
The probe gas sampling system can be unambiguously identified
by means of the specifications on the nameplate. The nameplate
is located in the inside of the control cabinet, on the internal side
of the door.
The nameplate is laid out as follows:
2
4
6
3
8 9
1 Company name and address
2 Product name
3 Year and location of manufacture
of the system
4 Serial no.
5 Configuration no.
Figure 30: Nameplate (example)
Note
Products that are marked with the adjacent symbol
may not be disposed of as unsorted municipal waste
(domestic waste).
They should be disposed of through separate
collection of electric and electronic devices.
1
5
7
6 General and UPS power supply
electrical connections
7 CE mark
8 Warning triangle acc. to EN
61010 – observe instructions
9 European Union WEEE sign- do
not throw in trash

Warning signs on the system

Meaning of the warning signs
Warning signs on the gas sampling probe warn about danger
areas.
The warning signs must always be in place and easy to see.
The following figures shows the location of the warning signs on
the individual modules:
4
4
4
4
Figure 31: Warning signs on the probe retractor
Figure 32: Warning signs on the control cabinet
Figure 33: Warning signs on the water panel