ABB ACS280 Firmware Manual page 124

124 Parameters
No. Name/Value
13.91 AO1 data storage
-327.68 ... 327.67
15
19 Operation mode
19.01 Actual operation mode
Zero
Speed
Torque
Min
Max
Add
Reserved
Scalar (Hz)
Forced magn.
19.11 Ext1/Ext2 selection
EXT1
EXT2
DI1
DI2
DI3
DI4
Supervision 1
Supervision 2
Supervision 3
Description
Storage parameter for controlling analog output AO1
eg. through fieldbus.
13.12 AO1 source
In parameter
storage
. Then set this parameter as the target of the
incoming value data. With the embedded fieldbus
interface, simply set the target selection parameter
of that particular data (
storage
).
Storage parameter for AO1.
Selection of local and external control location
sources and operating modes.
Operating modes of the drive
See section
Program features
.
Displays the operating mode currently used.
19.11
See parameters ...
This parameter is read-only.
None.
Speed control (in vector motor control mode).
Torque control (in vector motor control mode).
The torque selector is comparing the output of the
25.01 Torque reference speed
speed controller (
control
) and torque reference (
out
) and the smaller of the two is used (in vector
motor control mode).
The torque selector is comparing the output of the
25.01 Torque reference speed
speed controller (
control
) and torque reference (
out
) and the greater of the two is used (in vector
motor control mode).
The speed controller output is added to the torque
reference (in vector motor control mode).
Frequency control in scalar motor control mode.
Motor is in magnetizing mode.
Selects the source for external control location
EXT1/EXT2 selection.
0 = EXT1
1 = EXT2
EXT1 (permanently selected).
EXT2 (permanently selected).
10.02 DI delayed status
Digital input DI1 (
10.02 DI delayed status
Digital input DI2 (
10.02 DI delayed status
Digital input DI3 (
10.02 DI delayed status
Digital input DI4 (
32.01 Supervision status
Bit 0 of
32.01 Supervision status
Bit 1 of
32.01 Supervision status
Bit 2 of
AO1 data
, select
58.101 58.114 AO1 data
... to
in chapter
19.14
.
26.74 Torque ref ramp
26.74 Torque ref ramp
, bit 0).
, bit 1).
, bit 2).
, bit 3).
.
.
.
Default
FbEq 16
0.00
100 = 1
Scalar (Hz)
1
2
3
4
5
6
7...9
10
20
EXT1
0
1
3
4
5
6
25
26
27